kalmar wrote:
Hang on, is the receiver like this?
And the boiler like this?
If so, you need to go
Code:
boiler stat
1 2
2 L AND 3
3 N
Yes. Exactly that. Your diagram for the stat shows a volt free wiring diagram. My stat has that design, but it comes with a wire preinstalled bridging the 2 volt free connections. I read the (useless) instructions as meaning to leave that wire in place for the "standard" installation I am attempting, or remove it in order to wire in the volt free connections for a volt free installation.
Things are also not labelled up as 1, 2 , 3, 4 etc on the stat. Which is shit.
Hold on. I think I may have committed some stupidity by not reading the instructions properly. Cos that's not like me.